The main thing is to discard the old string and completely clean the racket. All cuts must be made quickly so that the racket frame is not deformed (this applies when they are high voltage) –
With the help of the punch, the broken ropes will be removed until it is left without old string, check the condition of the hoops and if there is any defective change it.
The string will be measured to string the entire racket, the length should not exceed 10 meters.
From the bottom to the top, the string must be introduced, starting with the center hoop on the bottom, a measurement of 2.5 meters will be made and the vertical strings will be introduced.

When the ten can be reached from the bottom of the bottom, the rope will be lifted, but when it is lowered, an egg must be left in the 11, in order to introduce the rope through the next one, that is to say, 12, a piece of string will be left to So start tensing and knotting.
If there is not enough rope, it will be pulled to achieve the necessary length and with the punch set the rope. To make it easy to link the horizontal strings, the rope is fixed with the punch on the cannula 12.
The remaining rope will be on the other side of the racket, the other end of the rope will be introduced on the free side of the racket starting with the lower left two cannons, leaving these with the vertical lines drawn, remembering the jump in the 12.
In the lower eight canisters, the rope will be introduced and the horizontal lines will be pulled until it coincides symmetrically with the eight.
The horizontal lines should continue to tighten in a reciprocating manner, the procedure should be carried out until reaching the Canutillo where the punch is located, it is removed and the ropes are tensioned where it will be put back.
Having all the strings, the ropes must be tensioned, starting with the vertical ones. If the chair is high tension it is necessary to use a stop that prevents the deformation of the racket.
The string that has been left as leftover will be used to knot. It is necessary to measure the necessary one and start to make the knot and apply the tension to the vertical ropes.
The punch should not be removed, which would prevent the first strings from losing tension. The new rope will allow the bonding to be applied in the middle of the two ropes and a knot will be made to secure.
After the tension applied to both the vertical and horizontal strings, they must be sanitized and the rest removed.
Remove the stop and thus the stringing of the badminton racket is finished.
Find some more sports information here 토토사이트